Pelco DX8100 Bedienungsanleitung PDF herunterladen (Seite 120)

120 C2631M-C (7/09)

3. To search for IP cameras connected to the network:

• Using the IP Camera Properties dialog box scan utility: The scan utility locates Pelco IP devices, IP cameras, and Axis IP

cameras.

NOTE: The DX8100 Client application IP Camera Properties scan utility is unavailable.

(1) Click Scan. The IP Camera Searching dialog box appears.

(2) After the IP Camera Searching dialog box closes, the IP scan results are displayed in the scan table.

NOTE: The scan results are cleared if the IP Camera Properties dialog box is closed.

Figure 85. DX8100 Scan Utility Results

• Using the Pelco Device Utility: For information about installing the Device Utility, refer to Utility Device for Pelco IP Cameras

manual.

NOTE: Install the Device Utility only on a remote computer. Do not install it on the DX8100 server.

(1) On a remote computer, start the Pelco Device Utility and allow the Device Utility to discover IP devices on the network.

(2) Search the Device Utility IP Address column for supported IP camera devices. For information about the supported IP cameras,

refer to DX8100 Series HVR Version 2.0 Release Notes. To access this document, go to http://www.Pelco.com and navigate to

the Hybrid Video Recorders page.

4. Note the IP address and model number of the supported IP cameras to be configured.

5. Assign each IP cameras to a DX8100 camera channel (refer to Assigning an IP Camera to a Camera Channel on page 120).

Assigning an IP Camera to a Camera Channel

The DX8100 allows you to select the video format and recording stream. The MPEG4 codec (video format) setting allows you to select the

primary or secondary stream. The MJPEG codec setting only supports the primary stream.

• Pelco IP cameras (IP110, IP3701, Spectra IP, and Spectra Mini IP): These cameras record as follows:

– Primary stream: 4CIF 30 ips

– Secondary stream: CIF 15 ips

• Pelco IX and IXE Series network cameras with Sarix

™

technology: The resolution, frame rate, and bit rate can be adjusted.

• Axis Communications

Axis 211 or Axis 232D: Frame rates are selectable from 1 to 30 ips; resolutions are selectable from 640x480,

480x360, 320x240, 240x810, or 160x120.

1. On the DX8100 toolbar, click the Setup button . The Setup dialog opens to the Camera page.

2. Click IP Camera Properties. The IP Camera Properties dialog box appears.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 250 251

Keine Kommentare

Pelco DX8100 Bedienungsanleitung Seite 120