Pelco DX9000 Bedienungsanleitung Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
Pelco Manual C684M-A (7/01) 3
CONNECTIONS
One, two, three, or four video storage units can be connected to a recorder, depending on
the requirements of your system.
Refer to Figure 2 to install the storage units.
1. Connect the appropriate end of the SCSI cable to the SCSI connector on each video
storage unit.
2. Read the Caution Notice in the
Mounting
section. Connect the other end of the
SCSI cable from each video storage unit to the SCSI connector in slot 1 of the re-
corder. Connect the first storage unit (labeled 01) to the upper left connector. Connect
the second storage unit (labeled 02) to the upper right connector. Connect the third
storage unit (labeled 03) to the lower left connector. Connect the fourth storage unit
(labeled 04) to the lower right connector.
3. Select the appropriate power cord (USA or European standard) and plug it into the
power receptacle on the back of each video storage unit. Plug the other end into a
power supply, preferably through an uninterruptible power supply.
4. Turn on the power switch on the back of one of the video storage units. Then open the
front door with the supplied key. Press the square button to turn on the power. Close
the door. The LEDs on the front of the unit light to show the hard drives are working.
5. Repeat step 4 for each storage unit.
6. Turn on the power switch on the back of the recorder. Then open the front door with
the supplied key. Press the square button to turn on the power. Close the door.
7. Go to the
System Configuration
section of the Installation/Operation Manual for the
Digital Video Recorder to continue with the installation procedure.
Figure 2. Connection Storage Units to Recorder
NOTE:
All video storage units
connected to a recorder must
be turned on
before
turning
on the recorder.
STORAGE UNIT #1
*
STORAGE UNIT #3
*
STORAGE UNIT #2
*
STORAGE UNIT #4
*
RECORDER
** STORAGE UNITS ARE NUMBERED AND MUST BE CONNECTED TO THE PROPER CONNECTOR.
00850
Seitenansicht 2
1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare