INSTALLATIONHeavy-DutySpectra® IV SeriesC3419M-B (11/06)In-Ceiling Back Box
10 C3419M-B (11/06)SPECTRAADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-871 ON ON ON OFF OFF OFF ON OFF72 OFF OFF OFF ON OFF OFF
C3419M-B (11/06) 11SPECTRAADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8151 ON ON ON OFF ON OFF OFF ON152 OFF OFF OFF ON ON OFF
12 C3419M-B (11/06)SPECTRAADDRESSSWITCH SETTINGSW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8223 ON ON ON ON ON OFF ON ON224 OFF OFF OFF OFF OFF ON O
C3419M-B (11/06) 13SpecificationsGENERALConstructionBack Box AluminumDome Drive Aluminum, thermoplasticLower Dome Clear polycarbonate, 0.090-inch th
14 C3419M-B (11/06)The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC
PRODUCT WARRANTY AND RETURN INFORMATIONWARRANTYPelco will repair or replace, without charge, any merchandise proved defectivein material or workmanshi
Worldwide Headquarters3500 Pelco WayClovis, California 93612 USAUSA & CanadaTel: 800/289-9100Fax: 800/289-9150InternationalTel: 1-559/292-1981Fax:
2 C3419M-B (11/06)InstallationBACKMOUNTINGPLATESMOUNTINGRINGCEILING153642
C3419M-B (11/06) 31. Locate the center point of the mounting location and insert the compass tool. Draw a circle.2. Cut the circle out of the ceiling.
4 C3419M-B (11/06)78VIDEOUTP+ UTP-RX- RX+ TX+TX-PWR- PWR+GNDAUX2GNDGNDNONCCOM7654321ALARMSAUX1
C3419M-B (11/06) 57. Install the back box by compressing the spring clips and pushing the back box through the hole. Tighten the screws until you hear
6 C3419M-B (11/06)TRIM LEASHBALL STUDBALL STUDRECEIVERBARREL KEY LOCKSWITCH 1 AND 211910
C3419M-B (11/06) 79. Configure DIP switches SW1 and SW2 located on the top of the dome drive. For DIP switch settings, refer to the labels located on
8 C3419M-B (11/06)Switch SettingsWARNING: If you are using D-type or P-type control, your system may not operate if the baud rate and address switche
C3419M-B (11/06) 9Table F. Switch Settings for SW1, P-Type ControlNOTE: For Coaxitron controls, SW1 is not used; set all switches OFF. For D-type c
Kommentare zu diesen Handbüchern