®INSTALLATION/OPERATIONC1407M-H (1/07)EH8100 SeriesPressurized Camera Enclosure
10 C1407M-H (1/07)EnvironmentalAmbient Operating Temperature -40° to 122°F (-40° to 50°C) (with heater)Vibration 5 to 60 Hz with 0.082-inch total tr
PRODUCT WARRANTY AND RETURN INFORMATIONWARRANTYPelco will repair or replace, without charge, any merchandise proved defective in material orworkmanshi
®Worldwide Headquarters3500 Pelco WayClovis, California 93612 USAUSA & CanadaTel: 800/289-9100Fax: 800/289-9150InternationalTel: 1-559/292-1981Fax
2 C1407M-H (1/07)ContentsImportant Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C1407M-H (1/07) 3Important Safety Instructions 1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.
4 C1407M-H (1/07)DescriptionEnclosures in the EH8100 Series are sealed and pressurized. They will accept CCD cameras with fixed focal length or motor
C1407M-H (1/07) 5Figure 1. EH8100 Series Enclosure - Rear ViewFigure 2. EH8100 Series Enclosure - Wiring DiagramSCHRAEDERVALVESPIRALRETAININGSPRING
6 C1407M-H (1/07)MATING CONNECTOR ASSEMBLYTo assemble the 16-pin mating connector, perform the following steps:1. Discard the white plastic sleeve th
C1407M-H (1/07) 7RECHARGING THE ENCLOSUREYou may use your own charging equipment or Pelco’s EH8000RKIT to recharge the enclosure. If you are using yo
8 C1407M-H (1/07)ServicingDISASSEMBLY1. Disconnect the power from the enclosure.2. Remove the mating connector from the rear of the enclosure by turn
C1407M-H (1/07) 9SpecificationsElectricalInput Voltage 120 VAC (230 VAC optional) for heatersPower Requirements 40 watts (EH8104)80 watts (EH8106)Con
Kommentare zu diesen Handbüchern