Pelco DVR C682M-E Bedienungsanleitung PDF herunterladen (Seite 7)

Pelco Manual C682M-E (11/01) 7

INSTALLATION

Place the DVR on any flat surface (desk or table) or install in any standard 19-inch (48.26 cm)

wide console or rack configuration.

Figure 1. Rear View of Back Panel

1 Camera Inputs – Refer to Table A for video coaxial cable distances.

2 Alarm Inputs

3 Analog Monitor Output

4 Relay Outputs

5 PC Monitor Output

6 LAN Port (Internet or TCP/IP)

7 NTSC/PAL Selection Switches – Setting must correspond with the software

setup for NTSC/PAL. Refer to Figure 6, item 2 .

8 Joystick Port (Not used)

9 Microphone Jack (Not used)

10 Audio IN/OUT (Not used)

11 COM 2 Serial Port – Connection for optional external modem.

12 Printer Port

13 COM 1 Serial Port – RS-422 two-wire control output; refer to Figure 2.

14 USB Connection – For optional USB device (CD-RW).

15 Keyboard (PS/2)

16 Mouse (PS/2)

17 AC Power Output

18 115/230 VAC Power Switch

19 AC Power Input

Table A. Video Coaxial Cable Requirements

Cable Type* Maximum Distance

RG59/U 750 ft (229 m)

RG6/U 1,000 ft (305 m)

RG11/U 1,500 ft (457 m)

* Minimum cable requirements:

75 ohms impedance

All-copper center conductor

All-copper braided shield with 95% braid coverage

00589

NOTE:

Set the PAL/NTSC

Switch to the proper setting

for your application. Refer to

NOTE:

An UPS (Uninter-

rupted Power Supply) is not

supplied with the DVR.

If required, Pelco recom-

mends a device with the

following specifications:

Capacity –

350 VA, 210 watts

Output voltage –

115 V

8% (on battery)

Frequency range –

47 Hz to 63 Hz

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Pelco DVR C682M-E Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Videorecorder (DVR) Pelco DVR C682M-E